report

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
report [2025/07/01 13:51] – [Abstract] team4report [2026/03/10 18:34] (current) – epsatisep
Line 2186: Line 2186:
  
 === Software === === Software ===
 +
 +
  
 The software differs for the prototype since there are only 2 valves and one water sensor used, the valves are both normally closed, and the microcontroller is an Arduino UNO instead of an ESP32. The software differs for the prototype since there are only 2 valves and one water sensor used, the valves are both normally closed, and the microcontroller is an Arduino UNO instead of an ESP32.
Line 2701: Line 2703:
 === Displacement Analysis === === Displacement Analysis ===
 <WRAP> <WRAP>
- +<figure displacement>  
-<figure displacement> {{ :displacement.png?400 |}} <caption>Displacement distribution</caption> </figure> </WRAP>+{{ :displacement.png?400 |}}  
 +<caption>Displacement distribution</caption>  
 +</figure>  
 +</WRAP>
 The displacement analysis shows maximum deformation of 0.02066 mm (2.066e-02), which is negligible for practical applications. The displacement pattern shows outward bulging of the tank walls, with maximum displacement occurring at the mid-height of the walls where bending effects are most pronounced. These minimal displacements confirm that the tank maintains its structural integrity and dimensional stability under the applied hydrostatic load. The displacement analysis shows maximum deformation of 0.02066 mm (2.066e-02), which is negligible for practical applications. The displacement pattern shows outward bulging of the tank walls, with maximum displacement occurring at the mid-height of the walls where bending effects are most pronounced. These minimal displacements confirm that the tank maintains its structural integrity and dimensional stability under the applied hydrostatic load.
  
  • report.txt
  • Last modified: 2026/03/10 18:34
  • by epsatisep